Operation specification for the hottest aerial wor

  • Detail

Operating specifications for aerial work vehicles

manned aerial work vehicles with hydraulic transmission are contemporary advanced mechanical equipment. With the help of aerial work vehicles, the safety of construction personnel can be guaranteed as long as they are used correctly. However, due to improper operation or failure to implement safety measures, it is also a very dangerous main air operation procedure, so the following code of conduct is formulated

1. Car drivers must hold bus driving licenses

2. The auxiliary gearbox must be separated from the hydraulic oil pump

3. Pay attention to the traffic height of bridges and tunnels

4. The vehicle speed is generally no more than 30 km/h, and no more than 40 km/h in the suburbs

5. No stranded personnel are allowed in the operation bucket (platform)

6. The parking position should be on a solid ground, and the inclination of the whole vehicle should not be greater than 3 °, and the warning flasher should be turned on

7. Working height and wind force (Beaufort)

wind force 6 and below, suitable for operation below 10m

the wind force is level 5, and the suitable height is below 11~20 meters

the wind force is level 4 and below, and the suitable height is below 21~30 meters

8. Start the oil pump, step on the car clutch, pull on the handbrake, put the gearbox in neutral gear, and pull the clutch pull rod of the hydraulic oil pump to make the hydraulic oil pump in working state

9. Operate each action handle only after the hydraulic oil pump operates for 2-5 minutes

10. The operation of aerial work vehicles should be the responsibility of personnel who have been trained and hold operation certificates

11. Operators should concentrate to prevent misoperation and strictly prohibit operation after drinking

12. First put down the outrigger, and if necessary, put the pad on the outrigger palm to ensure that the vehicle is in a horizontal state

13. When operating the handle, it should be stable and not rapid, so as to avoid excessive inertia swing of the working arm and accidents

14. Operate in strict accordance with the technical parameters and operation scope specified by the equipment

15. Workers on the operation platform (platform) should fasten their safety belts

3. Nut tensile test should be equipped with: one M32 universal screw nut

16. When lifting the operation platform (platform), the upper and lower arms should act alternately to ensure that the operation platform (platform) is in the best lifting radius state. It is strictly prohibited to use the operation arm for other purposes

17. During operation, operators should pay attention to the safe distance between the bucket (platform), arm and high and low voltage wires, wires, buildings, trees, billboards, lighting and other objects

18. The driver on duty is responsible for the ground and pays attention to the safety protection of passing vehicles

19. In addition to setting safety signs and guardrails, the ground supervisor, in addition to the driver, should also appoint someone to strengthen the supervision when using the operation vehicle with an operation height of more than 25 meters

20. In case of abnormal sound or sudden oil leakage in the hydraulic system during operation, the work shall be stopped immediately, and the work can be continued only after inspection or repair

21. When the hydraulic system fails and the operation arm cannot operate, try to make the staff on the operation platform (platform) evacuate safely, and notify the professional maintenance personnel to deal with it

22. After the operation is completed, and the bucket (platform) is perpendicular to the axis of the sample, the operation arm is reset, the outrigger is retracted, the hydraulic oil pump is disengaged, and the handbrake is released, then the crane can be started

23. The bucket (platform), working arm and outrigger of high-altitude operation shall have reflective safety signs

24. Aerial work vehicles should be equipped with 2 pieces of tripod (plastic shopping bags with a thickness of less than 0.025 mm are forbidden to be produced, sold and used nationwide; tires are used in all supermarkets, shopping malls, market fairs and other commodity retail places) skids and 4 outrigger skids

25. Horizontal marks shall be installed on the vehicle

Copyright © 2011 JIN SHI